Logik MP3-128 LCD User Manual

Safety
Listening to loud sounds for prolonged periods may permanently damage your hearing. Before
putting on the headphones, place them around your neck and turn the volume down. Then put
the headphones on and slowly increase the volume until you find a comfortable listening level.
Introducing the MP3 Player
The MP3 Player incorporates a portable WMA/MP3 Player, Voice Recorder and USB 2.0 Mass
Storage Device.
MP3 Player Features:
• WMA/MP3 player.
• Synchronous lyric display with WMA/MP3 music.
• Voice recorder.
• USB mass storage device.
• Integrated USB connector.
• Backlit display.
• Superb audio quality.
• No cable required.
• Requires 1 AAA / LR03 battery (supplied).
System support:
• Supports Windows Me/2000/XP.
Note for Windows Me/2000/XP users: Installation of the MP3 Player drivers is required
only if you wish to upgrade the firmware of the player.
Note for Windows 2000 users: Windows Service Pack 3 must be installed before installing
MP3 Player drivers.
• Supports Windows 98 SE after installation of drivers (see below).
• Supports Mac OS X (version 10.2.6 or above) without driver.
Note:
• To minimize static electricity, avoid operating the player in an extremely dry environment.
• Under the environment with electrostatic discharge, the product may malfunction and
requirement user to reset the product.

Logik MP3-128 LCD Specifications

System Memory

internal memory	128MB, 256 MB, 512 MB or 1 GB

Power

battery type	1 x AAA Battery
battery continuous playing time	Up to 8 hours

Display

display resolution	128 x 32 dots
display type	Dot-matrix LCD with backlight

Processor

processor speed	75 MIPS DSP

Audio

signal to noise ratio	> 90 dB
frequency response	20 Hz ~ 20 kHz
output power	< 11 mW (each output)