28
STARTING
1. Open the fuel valve by moving the slide control
to the right to the "ON" position.
2. To start a cold engine, set the choke to closed
position (lever to the left). To start a warm engine,
leave the choke in open position (lever to the right).
3. Turn the ignition switch to the "ON" position
and start the engine with the key.
4. With the software running, press the start button
while the enabling switch is pressed in.
5. This will increase the speed of the combustion
engine to its working rpm, and the bandsaw blade
will start.
6. If the choke is in closed position, gradually
move the control to open position as the engine
warms up.
STOPPING
The saw blade is stopped by releasing the control
lever or enabling the switch button. The bandsaw
blade is then deaccelerated to a standstill, and the
engine drops to idling speed. Now turn the engine
off by turning the key to the "OFF" position and
then closing the fuel valve.
STARTING AND STOPPING
To Next Page
Loading...
Need help?
General
