Logosol M7 User Manual

Sawmill
Manual
Read the safety instructions.
Customer order no:
M7 serial no:

Logosol M7 Specifications

General

Brand	Logosol
Model	M7
Category	Saw
Language	English

Summary

Safety Instructions

Service

Before using the M7 sawmill

During operation

Operational guidelines and safety precautions to follow while using the M7 sawmill.

Maintenance

Technical specifications

Assembly: Frame

Assembly: Guide Rail

Assembly: Adjusting Cross Beam and Strut

Assembly: Guide Rail Strut

Assembly: Log Side-Rest

Assembly: Log Bed

Assembly: Saddle Plate

Assembly: Rachet Mechanism

Assembly: Crank and Lifting Line

Assembly: Edge Support

Assembly: Saw Carriage

Assembly: Chain Guard

Assembly: Extender Nuts

Assembly: Chainsaw and Chain Guard Support

Assembly: Spiked Log Grip with Guard

Siting

Adjustments – Guide Rail

Adjustments – Log Bed

Adjustments – Guide Bar

Step-by-Step Sawing Instructions

Material drying

Trouble-shooting

Reasons for wrong measurements on an M7 sawmill

Identifies primary causes for inaccurate measurements during sawing operations.

Checking the M7

Checking the cutting equipment

Tensions in the wood

When the bar is not fitted straight

Cutting equipment

File before it slows down

Avoid chain breaks

The guide bar can pull askew

Keep the edge within the chromium layer

Regular chain sharpening

Fine-tuning the M7

Preparations

Make sure the bar is straight

Procedure to check and correct guide bar straightness before fine-tuning.

Ensure Guide Rail Straightness

Procedure to check for and correct warping of the guide rail.

Adjust Log Bed Angle

Verifying and adjusting the 90-degree angle between log bed and log support.

Verify Adjustments

Check Parallelism of Log Bed and Guide Bar

Ensuring parallel alignment between the log bed and guide bar for accurate cuts.

Fine-tuning the joint couplers

Adjusting the joint coupler