Logosol PH360 - User Manual

USER MANUAL
LOGOSOL PH360
Read through the user manual carefully and make sure you understand its contents
before you use the planer/moulder.
This user manual contains important safety instructions
WARNING! Incorrect use can result in serious personal injury or even death to the
operator or others.
USER MANUAL IN ORIGINAL FORMAT.
ARTICLE NO: 0458-395-0802

Summary

Safety Instructions

Key to Symbols

Explains warning symbols and safety pictograms used within the manual.

General Information and Safety Precautions

Safety Distance and Risk Area

Defines safe operating distances around the machine and identifies risk zones.

Machine Setup and Preparations

Assembly and Initial Setup Steps

Operating Procedures: Tables and Starting

Starting the Planer Safely

Critical checks and procedures before starting the planer.

Control Panel Functions

Understanding Control Panel Buttons

Explains the function and operation of each button on the control panel.

Bottom Cutter Operations

Setting and Adjusting Bottom Cutter Knives

Detailed steps for setting and adjusting the bottom cutter knives correctly.

Disassembling and Grinding Knives

Procedure for removing and sharpening the planer knives.

Top Cutter Operations

Setting and Adjusting Top Cutter Knives

Instructions for setting and adjusting the top cutter knives for precision.

Molding Knife Installation

Knife Assembly and Balancing Procedures

Steps for installing molding knives and ensuring cutter head balance.

Side Cutter Operations

Disassembling and Replacing Side Cutters

Guide for removing, maintaining, and replacing side cutters.

Side Cutter Adjustments and Grinding

Height Setting for Side Cutters

Knife Grinding Techniques

Fence Adjustment and Installation

Installing and Adjusting Side Fences

Moveable Cutter and Test Run

Moveable Cutter (Cutter 3) Adjustment

Steps for adjusting the moveable cutter for precise profiling.

Test Run and Profile Verification

Guidance on performing test runs and verifying profile accuracy.

Variable Feed Motor Operation

Setting Feed Speed and Indicator

General Maintenance and Storage

Regular Maintenance Schedule

Upper Chassis Plan Adjustment

Electrical Schematic (230 V 3-Phase)

Circuit Diagram for 230 V Operation

Electrical Schematic (400 V 3-Phase)

Circuit Diagram for 400 V Operation

Technical Data and Specifications

Machine Specifications and Performance

Detailed technical specifications, dimensions, and performance data of the PH360.

List of Components and Parts

Component Identification and References

Logosol PH360 Specifications