Logosol M7 User Manual

ALWAYS REMEMBER that
should any type of problem
occur, stop sawing and turn
off the chain-saw. Most
accidents with dangerous
machines happen when
something goes wrong and
the operator attempts to
x it while the machine is
still running. A stop seldom
shows up on the finished
product.
During operation:
To avoid tipping, never
place the machine at an
angle while operating.
The M7 should be fastened
directly to the floor or be
placed on a bedding of planks
in order to increase the contact
surface (follow the manual).
Hold the crank rmly whenever
raising or lowering a log. If
released, the crank may spin
back and hit your hand.
Do not place your hand
inside the long leg while
raising or lowering the log.
Should the lifting line snap or
the crank spin, your hand may
be caught.
Logs must always be rolled on
to the sawmill level with the
horizontal beam. Do not lift logs
from ground level directly onto
the sawmill as this can cause
injury if the machine tips or the
log falls.
Do not saw logs that are so
short that they do not extend
0.2 m (app. 10 “) outside each
log bed. A shorter log could fall
when the log beds are raised.
The overall max. load capacity
of the M7 is 500 kg (1100 lbs).
The 2.5 m extension increases
the capacity by 250 kg (550
lbs) for each extension with a
lifting unit.
Always stand to the right
of the chain-saw while it is
operating.
When a chain or band
breaks, it is thrown out
through the chip outlet.
Keep the worksite free of tools,
pieces of wood, chips and other
items you can trip on.
Turn the chain-saw off after
each cut. Do not leave the
M7 sawmill unattended where
unauthorized persons might
start it.
When using a petrol-
driven chainsaw:
Fire danger – Turn the motor
off before filling with petrol.
Petrol is extremely ammable!
Burns can cause death! If you
spill any fuel, clean off any parts
involved. If you get fuel on your
clothing, change immediately.
Close the tank lid as tightly as
possible in order to reduce the
risk of it coming loose due to
vibrations during sawing.
Never operate the chain-saw
with the throttle lever locked.
Always operate the throttle
manually.
Do not use a ripping chain for
cross-cuts as this increases
the danger of kickback.
Before using the M7
sawmill:
Check the condition of the
lifting lines especially carefully,
replacing them at the slightest
sign of wear. Check that all
bolts and lock nuts on the log
bed lifting unit and the locking
system are tight and that all
moving parts move freely.
To avoid tipping, check that
the M7 stands level and is well
fastened in the bedding.
To avoid chain breaks, check
that the cutting equipment is
correctly assembled.
To avoid kickbacks when star-
ting, check that the chain-saw
is correctly positioned on the
guide rail.
7
Service:
The M7 sawmill must be checked
regularly and maintained as
needed.
Perform only the maintenance
and repairs specified in the
manual. Other repairs must be
done by Logosol or by authorized
Logosol dealers.
Do not make any alterations in
the construction of the sawmill
as this can increase the accident
risk. After service, the M7 sawmill
should be returned to its original
condition. Logosol accepts no
liability for damage that occurs
while working on an improperly
modied machine.

Logosol M7 Specifications

General

Brand	Logosol
Model	M7
Category	Saw
Language	English