Long range MT4300 - Program Menu Details; Selecting and Assigning Programs; Bird Type and Trap Assignment

4
5
6
7
Select User Program
From the Program Menu, press a button 1-6
to select the User Program you would like to
create or overwrite.
*If there is already a sequence programmed,
you will be asked if you would like to overwrite
it.
Choose Bird Type for Stand 1, Se 1
The cursor will be ashing next to Bird Type.
sing the up 8 and down 0 arrows, cycle
through the bird types and choose the one
needed. Press NTR.
Assign the Traps to be Used
The cursor will be ashing next to 1st Trap.
sing the keypad, enter the trap number of
the rst trap to be red. If it is a double digit
number, you must press ero rst, then the 2
digit number. Press NTR. The cursor will
move down to second trap if a pair is to be
thrown. nter the second trap number. Press
NTR.
Complete Programing
Continue programing the stands and
sequences until nished. ach menu may not
use all 5 available sequences. se the NON
Bird Type to ignore the sequences that are
not needed. When you nish, the MT4300 will
briey display Programing Complete before
returning to the Program Menu.
User Prog. 11
2
3
4
User Prog. 2
User Prog. 3
User Prog. 4
Stand 1 Seq 1
Bird Type - None
1st Trap
2nd Trap
0
0
Stand 1 Seq 1
Bird Type - Single
1st Trap
2nd Trap
0
0
Programming
Complete
Available Bird Types:
None: Ignores the sequence.
Single: Single target. ser only needs to assign 1st Trap.
Pair: True pair. Press the PLL button once to release the two targets. ser needs to assign the 2
traps that are to be red simultaneously.
Report: Report pair. Press the PLL button on call to release the rst target, then again when the rst
target is shot at to release the second target. ser needs to assign the 2 traps that are to be red.
Rafale: Following pair from the same trap with a delay of 2.5 seconds between the two targets.
Typically seen in FITASC sporting. eep in mind that this kind of target will empty a trap quickly.
21