Long range MT4300 - FITASC Program Menu Details; Assigning FITASC Traps

5
6
7
Choose Bird Type for Stand 1, Se 1
The cursor will be ashing next to Bird Type.
sing the up 8 and down 0 arrows, cycle
through the bird types and choose the one
needed. Press NTR.
Assign the Traps to be Used
The cursor will be ashing next to 1st Trap.
sing the keypad, enter the trap letter of the
rst trap to be red. Press NTR. The cursor
will move down to second trap if a pair is to
be thrown. nter the second trap letter. Press
NTR.
Complete Programing
Continue programing the stands and
sequences until nished. ach stand may not
use all 7 available sequences. If not, use the
NON Bird Type to ignore the sequences that
are not needed. When you nish, the MT4300
will briey display Programing Complete
before returning to the Program Menu.
Stand 1 Seq 1
Bird Type - None
1st Trap
2nd Trap
0
0
Stand 1 Seq 1
Bird Type - Single
1st Trap
2nd Trap
0
0
Programming
Complete
Available Bird Types:
None: Ignores the sequence.
Single: Single target. ser only needs to assign 1st Trap.
Pair: True pair. Press the PLL button once to release the two targets. ser needs to assign the 2
traps that are to be red simultaneously.
Report: Report pair. Press the PLL button on call to release the rst target, then again when the rst
target is shot at to release the second target. ser needs to assign the 2 traps that are to be red.
Rafale: Following pair from the same trap with a delay of 2.5 seconds between the two targets.
Typically seen in FITASC sporting. eep in mind that this kind of target will empty a trap quickly.
23