LongerPump BT100-1F - Operation Panel; Basic Operation

1
Operation Panel
2
Start/Stop Key
Exit Key
Direction Key
Prime Key
Knob
S1
S2
P3
P2
P4
P1
LCD Display
Power Switch
Introduction
Applicable pump heads for BT100-1F are YZ1515x, YZ2515x, YZII15, YZII25 and
DG-1, DG-2, DG-4. The pump delivers flow rates from 0.16 L to 500 mL / min
and dispensing volume is from 0.01 mL to 9.99 L. Combining 128 32 LCD
display with membrane keypad and rotary coded switch makes the operation
easy and prompt. The speed can be adjusted manually or automatically through
external control interface.
μ
×
Note:
Ref. page 11 to know detailed external control function.
The pump must be grounded properly before operating in order to protect the
operator in moist environment.
S Standard Configuration
S1 Pump Head
S2 Drive
PPart
P1 Signal Output Port
P2 External Control Input Port
P3 Power Socket
P4 Infuse Holder
Basic Operation
Start/Stop Key
Direction Key
Knob
Knob
Knob
Knob
Prime Key
Prime Key
Prime Key
Exit Key
Exit Key
Power Switch
Press to start or stop the pump
Press to change the rotation direction of the pump
Function 1: Turn the to adjust flow rate under none-prime working status.
Function 2: Menu selection function, turn the to select menu and set the
parameters, press to confirm the selection.
In common state, press the to enter prime state when the pump runs
at full speed for empting, filling and rinsing operation; Press the
again to return to common state. In prime state, other keys are invalid.
Function 1: Cancel current operation and return to previous menu.
Function 2: In dispensing working mode, press to check current speed
and the needed time for dispensing the set volume.
Turn on or off the pump.
BT100-1F OPERATING MANUAL
BT100-1F OPERATING MANUAL