Why is the arc inconsistent on my Longevity Welding System?
To fix an inconsistent arc with your Longevity Welding System, check and replace the consumables, and adjust the regulator to the proper PSI. This issue can arise from improper grounding or low air pressure.
How to reduce heavy underside slag (cutting) with Longevity Welding System?
If you're getting heavy underside slag when cutting with your Longevity Welding System, try increasing the travel speed or the amperage on the unit.
Why is the cut quality poor with my Longevity Welding System?
If you're experiencing poor cut quality with your Longevity Welding System, first check the air pressure. Make sure your unit can cut the material thickness you're using. Inspect the consumables to ensure they produce a stable arc. Replace the consumables and ensure you have the correct PSI at the regulator.
Covers warnings related to function modes, electric shock, smoke, arc light, and welding splash.
Provides guidance on troubleshooting machine faults by referring to the manual or contacting support.
Details on connecting the plasma cutter to a 220V power source, emphasizing safety and proper wiring.
General| Plasma Gas Type | Compressed Air |
|---|---|
| Input Voltage | 110/220V |
| Output Current | 40A |
| Duty Cycle | 60% @ 40A |
| Maximum Cutting Thickness | 12mm |
| Dimensions | 15 x 6 x 12 inches |
To Next Page
