To Next PageTo Next Page
Need help?Do you have a question about the Lopi Stove and is the answer not in the manual?
Provides essential details for registration, warranty, and record-keeping.
Details heating capacity, BTU output, efficiency, and burn time.
Provides physical dimensions and weight of the stove.
States emissions compliance information.
Guidance on planning the installation, dealer consultation, and permits.
Instructions for checking stove condition and preparing for installation.
Details common installation types and their considerations.
Specifies requirements for floor protection materials and dimensions.
Outlines clearances needed around the stove for safety.
Provides a table of minimum clearances to combustibles for various setups.
Illustrates clearances for a straight-through top vent installation.
Illustrates clearances for a corner top vent installation.
Instructions for installing the bypass handle.
Details how to configure the rear vent for masonry fireplace installations.
Specifies requirements for the chimney connector, materials, and routing.
Details requirements for the chimney system, including type and height.
Specifies requirements for chimney cap and termination height above the roof.
Outlines the requirements for outside air intake, especially for mobile homes.
Details special requirements for installing the stove in an alcove.
Lists specific requirements for installing the stove in a mobile home.
Illustrates a standard ceiling installation with a factory-built chimney.
Illustrates a cathedral ceiling installation with a factory-built chimney.
Shows a hearth stove installation with a positive connection to a masonry fireplace.
Shows a hearth stove installation with a direct connection to a masonry fireplace.
Illustrates an installation using an interior or exterior masonry chimney.
Advises on safe operation of a hot stove.
Steps to take before lighting the stove for the first time.
Explains the process and precautions for curing the new paint.
Warning and guidance on how to avoid and identify over-firing.
Instructions on how to safely open and close the stove doors.
Explains the function and operation of the bypass control.
Instructions for safely operating the loading lid.
Provides guidance and warnings for starting a fire in the stove.
Details a specific method for starting a fire.
Explains how to adjust the air control to manage the burn rate.
Provides recommended air control settings for different burn types.
Instructions for safe and proper ash removal and disposal.
Details the procedure for removing the ashpan.
Explains how to operate the optional blower.
Provides instructions for safely re-loading the stove.
Guidance on achieving an overnight burn.
Describes expected sounds during normal stove operation.
Offers tips for efficient and effective wood burning.
Guidance on choosing the right type of wood for burning.
Explains the benefits and reasons for using dry wood.
Provides advice on cutting and storing wood for optimal burning.
Visual guide demonstrating the steps for starting and maintaining a fire.
Continues the visual guide for fire starting and maintenance.
Lists common problems and their possible causes and solutions.
Daily tasks to keep the stove in good working order.
Detailed instructions for removing ashes.
Guidance on cleaning the stove glass.
Monthly tasks for maintenance and inspection.
How to inspect the door and glass for proper sealing.
Information on creosote formation and the importance of its removal.
Instructions for cleaning the combustion brick.
Tasks to be performed annually.
How to use touch-up paint for minor repairs.
How to clean the air duct and blower.
How to adjust the ashpan latch for a secure fit.
Instructions for cleaning the combustor area.
Identifies the various parts of the stove door assembly.
Step-by-step guide for replacing the stove glass.
Instructions for replacing the door gasket.
Instructions for replacing the loading lid gasket.
Identifies the various parts of the firebox.
Instructions for removing and replacing firebox bricks.
Instructions for removing and replacing the combustor.
Details warranty coverage for the first year, including parts and labor.
Details warranty coverage for the second and third years.
Details warranty coverage for the fourth and fifth years.
Lists conditions and exclusions that may void the warranty.
Provides instructions on how to obtain warranty service.
Presents essential safety cautions for operation and maintenance.
Details clearance requirements for freestanding installations.
Diagram illustrating clearance measurements for freestanding setups.
Diagram showing floor protection requirements.
Step-by-step guide for installing the rear blower.
General
