Setting the Date and Time
10
To enable automatic DSTadjustments:
1. Click the DST Setup button.
2. Configure the following:
• Daylight Saving Time: Select Enable.
• Time Offset: Select the number of hours the system should move forward or backward when DST
occurs.
• Daylight Saving Time Mode: Select Week or Date. This allows you to select whether DSTshould
begin and end at the beginning of the week or on a specific date.
• Start Time, End Time: Enter when DST starts and ends.
3. Click Apply to save your settings.
10.2 Using a NTP Server to set your System Time
A NTP (Network Time Protocol) server syncs your system time with an online time server.
Lorex provides a free NTP service that allows your DVR to automatically update the time
for Daylight Savings Time.
Note
A constant Internet connection is required to use the NTP feature.
To enable NTP:
1. Right-click to open the Menu Bar and click the Main Menu button (
).
#LX400015; r. 1.0/13705/13705; en-US
23
To Next Page
Loading...
