GETTING STARTED
I. Open the Barrel: Remove nut
and washer, press down on bolt
with thumb while lifting up on
outside of outer lid with fi ngers.
If outer lid is diffi cult to
remove, insert washer between
edge of outer lid and barrel,
twist to loosen. After outer lid
has been removed, lift inner lid
out by center bolt.
II. Add Rocks: Fill Barrel about
1⁄2 to 2/3 full of rock. Rocks
should be of assorted sizes for
best results.
III. Add Abrasive: Add
60/90 Silicon Carbide
Abrasive. Use 4 level
Tbsp for a 1.5 - 3 Lb.
barrel. Use 6-8 level
Tbsp for a 4 lb. barrel.
Add water to top layer
of rocks and abrasive.
Do not overfi ll.
IV. Close the Barrel: Wipe the mating surfaces of the barrel
and inner lid clean with a damp cloth. Press inner lid into
barrel until it rests on shoulder. Press outer lid fi rmly down
onto the barrel. Install washer and tighten nut.
Knurled nut only needs to be snug Do Not Use tools to
tighten. Over tightening of the nut can cause the inner lid
to distort and leak.
Add rocks
until 2/3 full.
Add water to
top layer of
rocks.
2
To Next Page
Loading...
