*988-12758-003*
Elite FS
®
Installation Guide
Technical specications
In the box
C
A
D
B
A Elite FS
®
unit
B Gimbal bracket kit
C Sun cover
D Power cable kit
7” 9”
Environmental
Operating temperature range -15°C to +55°C (5°F to 131°F)
Storage temperature -20°C to +60°C (4°F to 140°F)
Waterproof rating IPX6 and IPX7
Electrical
Supply voltage 12 V DC (10 - 17 V DC min - max)
Fuse rating 3 A
Power consumption (maximum) 28 W (2 A at 13.8 V DC)
Display
Resolution 800 x 480 pixels
Viewing angles in degrees 50° top, 60° bottom
70° left and right
Brightness > 1200 nits
Touch screen Multitouch
Physical
Weight (display only) 0.9 kg (1.9 lbs) 1.2 kg (2.7 lbs)
Compass safe distance 0.5 m (1.6 ft)
Interface/Connectivity
NMEA 2000
®
1 port (Micro-C connector)
Data card reader 1x slot (microSD, SDXC)
Ethernet 1 port (5-pin Ethernet connector, 100Base-T)
Sonar 1 port (9-pin connector)
Wi-Fi
®
internal 802.11b/g/n
Bluetooth
®
4.0 with support for Bluetooth
®
Classic
GPS 10Hz high speed update
WAAS, MSAS, EGNOS, GLONASS
Copyright
©
2024 Navico Group. All Rights Reserved. Navico Group is a division of Brunswick Corporation.
®
Reg. U.S. Pat. & Tm. Off, and ™ common law marks.Visit www.navico.com/intellectual-property to review the global trademark rights
and accreditations for Navico Group and other entities.
Compliance statements
Declarations
The relevant declarations of conformity are available at:
www.lowrance.com.
Europe
This product complies with CE under the Radio Equipment
Directive 2014/53/EU.
United Kingdom
This product complies with UKCA under The Radio
Equipment Regulations 2017.
United States of America
This product complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
This device must accept any interference received, including
interference that may cause undesired operation.
! Warning: The user is cautioned that any changes
or modications not expressly approved by the party
responsible for compliance could void the user’s authority
to operate the equipment.
¼ Note: This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that the interference will not occur in
a particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and
receiver
• Connect the equipment into an outlet on a circuit
different from that of the receiver is connected
• Consult the dealer or an experienced technician for help.
Canada
This product complies with ISED (Innovation, Science and
Economic Development) Canada’s license-exempt RSSs.
Operation is subject to the following two conditions: (1) This
device may not cause interference, and (2) This device must
accept any interference, including interference that may
cause undesired operation of the device.
Australia
This product complies with ACMA according to
Radiocommunications Labelling (Electromagnetic
Compatibility) Notice 2017 and Radiocommunications
(Compliance Labelling - Devices) Notice 2014.
New Zealand
This product complies with RSM according to
Radiocommunications (EMC Standards) Notice 2019 and
Radiocommunications (Radio Standards) Notice 2020.
To Next Page
Need help?
General
