Cleaning the auxiliary heads
!
All the maintenance operations described in this section must be carried out with the unit switched off and the supply
cable disconnected. This chapter does not apply to Cellu M6 Keymodule i.
33
!
These functions are only possible provided the auxiliary treatment head has been selected.
Functions
incorporated in the auxiliary adapter
32
Because the control is incorporated in the
auxiliary head connection, you can start or
stop your treatment by operating the START/
STOP switch and adjust the treatment inten-
sity using the +/- keys without having to go to
the control panel of your unit.
Auxiliary
heads serie 600 - active
TYPE: 630A
TYPE: 644A
TYPE: 615A
↔
↔
.F
When used for specific purposes such as the
after-effects of burns or lymphoedema,
the treatment heads must be thoroughly
disinfected after use:
1. After following the cleaning procedure
described above, soak the head (auxiliary
head, micro-head and micro-nozzle) and
the rollers in a disinfectant solution for
15 minutes.
2. Rinse carefully.
3. Leave to dry.
Warning: Use a non-alkaline disinfectant that complies with
AFNOR standards and has the following microbiological
properties: Bactericide (NF EN 1040, NF T 72-171, NF T 72-
190, T 72-300/301), Fungicide (NF EN 1275, NF T 72-200).
For reasons of hygiene, the treatment
heads should be cleaned before and after
each use with the heads disconnected
from the machine. Use antiseptic wipes
and a bactericidal and fungicidal solution.
Lift head:
1. Before use, clean the flaps and the side
plates.
2. After use, remove the flaps from the head
for more thorough cleaning. Grasp the
flaps between the thumb and index finger
and pull them upwards.
3. Next clean the head’s transparent side
plates with antiseptic wipes and a bacteri-
cidal and fungicidal solution.
Cleaning the lift heads
To Next Page
Loading...
