LPG Cellu M6 - Description of the Controls; Control Panel Overview; Main Head Controls; Precautions for Use

• Check that the supply voltage of the unit
indicated on the data plate complies
with the mains voltage.
• The unit must be connected to a grounded
outlet in accordance with current electri-
cal standards.
• Never use the unit on a dusty, uneven
floor, or in a moist atmosphere.
• Check that the inlet to the ventilation
circuit is always unobstructed.
• Fully unwind the supply electrical from
its support to ensure good ventilation
of the unit.
• Switch the unit off if it is not going to
be used for a long period. In this case,
operate the machine for a 1/2 an hour
approximately every 8 weeks.
• Do not allow solid debris or liquid to be
sucked into the unit, as these could
cause damage.
• Never use the auxiliary adapter as a treat-
ment head or allow it to come into direct
contact with the skin.
• Do not use the main head to carry out
treatment on the scalp.
• Only use the treatment heads supplied with
your unit or recommended by LPG.
• Only use LPG Systems treatment garments.
• Never use the unit for purposes
other than those recommended
by LPG Systems.
• LPG Systems will not be liable for any
inappropriate use of the equipment.
• With respect to treated tissue, some
parameters may cause pain or tissue
lesions. The operator must be particularly
attentive to the sensations felt by the person
undergoing treatment where:
- the intensity is greater than 4 in continuous
or sequential mode
(for frequencies less than 4 Hz),
- the system has changed to reverse mode
(rollers rotating in opposite direction).
• The operator must ensure that the
parameters (intensity, sequentiality,
differential...) are always adapted
to the cutaneous tissue being treated.
• You are advised to rest the device for
10 minutes between each 35-minute
treatment session when using it at a room
temperature higher than 25°C (77°F).
!
Where the unit has not been used for a long time, it is possible that marks may form on the ground where the wheels
are. This phenomenon is the result of a chemical reaction between the components of some floorings and those of the
wheels of the Cellu M6 Keymodule [2] i.
PrecautionsControl panel
Main head
2
description of the controls
3
precautions for use
8 9
control screen
stop/start key
parameters
keys
return to
menu
escape
key
program
selection
keys
roller speed
adjustment keys
frequency
adjustment
keys
roller
selection key
initial roll
selection key
stop/
start keys
control screen