4 -3
HST type
1. Sit in driver’s
seat and apply
parking brake
2. Place range gear shift lever and HST
forward/reverse pedal in NEUTRAL,
and PTO switch in “OFF” position.
6. Turn key switch to
“START” position. As
soon as the engine
starts, release the key
switch to “ON” position.
7. Check if the battery charging
indicator and engine oil
pressure indicator are OFF
after starting engine.
If not, stop the engine
immediately and check the
problem.
Brake pedals
HST reverse pedal
Throttle lever
HST forward pedal
PTO switch
Key switch
Parking brake lever
3. Pull the throttle lever to
the low speed position.
5. Wait until the cold start
aid indicator is OFF.
(about 10 seconds)
4. Turn key switch to “ON”
position and check if
the battery charging
indicator, engine oil
pressure indicator and
cold start aid indicator
are ON.
8. Run the engine for a
few minutes to allow the
engine oil and
transmission oil to warm
up.
Caution
▶Check each part before starting
engine.
▶Check if there are any other
people around before starting.
▶Place all the transmission gear
levers and switches in
NEUTRAL or “OFF” position.
To Next Page
Loading...
