3 -21
Forward
Reverse
Shuttle lever
Throttle lever
(11) Shuttle lever (Synchro-shuttle)
This is used to select the Forward or Reverse.
FORWARD : Push the lever forward.
REVERSE : Pull the lever backward.
Before reversing the tractor, lower the engine
speed and check the safety conditions behind
your tractor.
Before starting engine, be sure to place the
shuttle lever in neutral position.
(12) Throttle lever
This lever is used to control engine speed.
- pull it backward for HIGH engine speed.
- push it forward for LOW engine speed.
The throttle lever must be used only for work
field. When driving on the road, place the throttle
lever to the low speed position, and use the
throttle pedal.
▶ The synchro-shuttle shift lever allows any forward range or reverse to be shifted
while the tractor is moving slowly. However, the clutch must be disengaged and
engaged by means of clutch pedal. Make sure to depress clutch pedal fully and
release it gradually to take up load smoothly, but sudden gear shifting may cause
transmission damage. It is recommended to stop the tractor before operating the
shuttle lever.
Caution
To Next Page
Loading...
