LS Starvert SV-iC5 User Manual

Easy Start Guide
LS Industrial Systems
Starvert SV-iC5 Frequency Inverter
available from LS.InverterDrive.com
RUN STOP/RST
FWD
REV
min max
This guide is intended to compliment the user manual provided by the manufacturer.
It is provided as a basic introduction to the product for Inverter Drive Supermarket customers.
It should not be used as a replacement for the manual issued by the manufacturer.
v1.2
20110316
This product is not a safety device. All safety considerations including but not
limited to Emergency Stop provision should be assessed separately and are
outside the scope of this guide.

LS Starvert SV-iC5 Specifications

General

Category	DC Drives
Series	SV-iC5
Enclosure	IP20
Overload Capacity	150% for 60 seconds
Braking Unit	Built-in
Protection Functions	Overcurrent, Overvoltage, Undervoltage, Overheat, Short circuit
Communication	RS485
Cooling Method	Fan cooling
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheat, Short Circuit

Summary

1. Power and Motor Connections

2. Motor Connections - Star and Delta

4. Parameters for Initial Setup

4.1 Drive Group Parameters

Configures control sources for Run/Stop and speed adjustment using integrated controls.

4.2 Function Group 1 (F) Parameters

Sets key motor operating parameters like max frequency, base frequency, and torque boost.

4.3 Function Group 2 (H) Parameters

Defines motor characteristics such as power, poles, slip, and current ratings for accurate operation.

5. Setting Motor No-Load Current (H34)

6. How to Set a Parameter Value

7. Operating the Inverter

12. Resetting Inverter to Factory Defaults