II
WARNING
n Do not remove the cover while power is applied or the unit is in
operation.
Otherwise, electric shock could occur.
n Do not run the inverter with the front cover removed.
Otherwise, you may get an electric shock due to high voltage terminals or charged
capacitor exposure.
n Do not remove the cover except for periodic inspections or wiring,
even if the input power is not applied.
Otherwise, you may access the charged circuits and get an electric shock.
n Wiring and periodic inspections should be performed at least 10
minutes after disconnecting the input power and after checking the
DC link voltage is discharged with a meter (below DC 30V).
Otherwise, you may get an electric shock.
n Operate the switches with dry hands.
Otherwise, you may get an electric shock.
n Do not use the cable when its insulating tube is damaged.
Otherwise, you may get an electric shock.
n Do not subject the cables to scratches, excessive stress, heavy
loads or pinching.
Otherwise, you may get an electric shock.
To Next Page
Loading...
