16
PROG /
TIME
SETTING TIME/20 = INTERVAL RUNNING TIME
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
P0
14
SPEED
2 2 4 5 6 5 4 3 2 1 2 3 4 5 6 5 4 3 2 1
INCLINE
4 4 4 4 3 3 6 6 6 7 7 8 8 9 9 6 6 5 4 4
P0
15
SPEED
2 4 6 8 6 6 4 4 2 2 2 4 6 8 6 6 4 4 2 2
INCLINE
3 3 3 4 4 5 5 5 4 4 4 4 5 5 3 3 3 2 2 2
P0
16
SPEED
2 4 6 8 10 8 6 4 2 2 2 4 6 8 6 6 4 4 2 2
INCLINE
5 5 5 6 6 6 4 4 6 6 5 5 8 8 9 9 9 7 4 1
P0
17
SPEED
2 2 6 6 8 10 6 6 2 2 2 2 6 6 8 10 6 6 2 2
INCLINE
4 5 5 5 6 6 6 7 8 9 9 9 10 10 10 12 12 8 6 3
P0
18
SPEED
2 3 4 5 2 3 4 5 3 2 2 3 4 5 2 3 4 5 3 2
INCLINE
4 4 4 4 3 3 6 6 6 7 7 8 8 9 9 6 6 5 3 2
P0
19
SPEED
2 4 6 2 4 6 2 4 6 2 2 4 6 2 4 6 2 4 6 2
INCLINE
3 5 5 5 4 4 4 3 3 3 3 4 4 4 3 3 3 4 3 2
P0
20
SPEED
1 3 4 5 6 5 4 3 2 1 1 3 4 5 6 5 4 3 2 1
INCLINE
3 3 3 4 4 5 5 5 4 4 4 4 5 5 3 3 3 2 2 2
7.1. Setting
Press MODE key enter to user setting, the speed & incline window show the value of the segment. Use
the Speed +/- or Incline ^/v to adjust settings. Press the MODE button to confirm and move to the next
segment. After finishing the 20th time setting your data will be saved until it is changed by next user.
This data will not be lost by outage.
7.2. Start
A: Under standby mode, press "PROG" continuous to set user defined program (U01-U03) directly. When
time setting is ready, press "START" to start.
B: After setting user program and time, press START to start running.
7. USER DEFINED PROGRAM
| OPERATION GUIDE
To Next Page
Loading...
