THE GS320 SYSTEM
5: CERTIFICATION NOTES
5.1 FCC and IC—Instructions to the User
This equipment has been tested and found to comply
with the limits for a class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy
and if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
In order to maintain compliance with FCC regulations,
shielded cables must be used with this equipment.
Operation with non-approved equipment or unshielded
cables is likely to result in interference to radio and TV
reception.
FCC ID: QVBGS300 IC: 7076A-ICGS300
RF Exposure Warning:
This product complies with FCC/IC radiation exposure
limits set forth for an uncontrolled environment. To
comply with RF exposure requirements, the unit must
be installed and operated with 20 cm (8 in.) or more
between the product and your body. This product may
not be collocated or operated in conjunction with any
other antenna or transmitter.
This device has been designed to operate with the
antennas listed below, and having a maximum gain of
2.0 dB. Antennas not included in this list or having a gain
greater than 2.0 dB are strictly prohibited for use with this
device. The required antenna impedance is 50 ohms.
To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is not
more than that permitted for successful communication.
FCC ID: QVBGS000 IC: 7076A-ICGS000
RF Exposure Warning:
This product complies with FCC/IC radiation exposure
limits set forth for an uncontrolled environment. To
comply with RF exposure requirements, the unit must
be installed and operated with 20 cm (8 in.) or more
between the product and your body. This product may
not be collocated or operated in conjunction with any
other antenna or transmitter.
This device has been designed to operate with the
antennas listed below, and having a maximum gain of
3.0 dB. Antennas not included in this list or having a
gain greater than 3.0 dB are strictly prohibited for use
with this device. The required antenna impedance is 50
ohms.
To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is not
more than that permitted for successful communication.
ANTENNA LIST
LSI-Robway P/N: TA011
Description: 1/4 wave monopole
MFG LSI-Robway
ANTENNA LIST
LSI-Robway P/N: TA008
Description: 1/2 wave dipole
MFG Nearson
MFG P/N: S467AH-915S
SkyAzúl, Equipment Solutions
To Next Page
Loading...
Need help?
General