LSIS SV037iG5A-2 - Parameter Initialize;Lock

8-31
8.25 Parameter Initialize / Lock
z Parameter initialize
Group Display Parameter Name Range Default
Function
group 2
H93 [Parameter initialize] 0
- 0
1 4 groups initialize
2 Drive group initialize
3 F 1 group initialize
4 F 2 group initialize
5 I/O group initialize
 Select the group to be initialized and perform it in H93 code.
 Press Enter (z) key after setting in H93. H93 will be displayed again after initialization is
complete.
z Password register
Group Display Parameter Name Setting Range Default Unit
Function
group 2
H94 [Password register] -
0 ~ FFFF 0
H95 [Parameter lock] - 0 ~ FFFF 0
 Register password for Parameter lock (H95).
 Password should be Hex decimal. (0 ~ 9, A, B, C, D, E, F)
CAUTION
After setting modification lock function of H95, Do not forget the registered
password. if you try to release lock, you need the registered password.
 Factory default password is 0. Enter the new password except 0.
 Follow the steps below when you register the password for the first time.
Step Note Keypad display
1 Move to H94 code. H94
2 Press Enter (z) key twice. 0
3 Register password. (Ex: 123) 123
4 123 will blink when Enter (z) key is pressed. 123
5 Press Enter (z) key. H94