LSIS SV037iG5A-2 - Stop Method Selection

7-20
7.6 Stop method select
z Decel to stop
Group Code Parameter Name Setting Range Initial Unit
Function group 1
F4 [Stop mode select] 0
0 ~ 3 0
 Select 0 {decel to stop} in F4 code.
 Motor decelerates to 0 Hz and stops during the setting time.
z DC braking to stop
Group Code Parameter Name Setting Range Initial Unit
Function group 1
F4 [Stop mode select] 1
0 ~ 3 0
 Select 1 {DC brake to stop} in F4 code.
 Refer to page 8-1.
z Free run stop
Group Code Parameter Name Setting Range Initial Unit
Function group 1
F4 [Stop mode select] 2
0 ~ 3 0
 Select 2 {Free run stop} in F4 code.
 When operating command is turned OFF, Output Frequency and voltage are shut down.
Operating
command
Freq.
Decel
time
Operating
command
Freq, Voltage