Registers
Modbus RS485 Interface
Operating Guide
- 59 -
Registers
pH / Redox Input Calibration Continued
6718 Get/Set Channel 1 Calibration
Alarm Year*
INT Calibration Alarm Year
*(Only available when
Calibration Reminder set
to yes)
Max 2099 Year
7098 Channel 2
7478 Channel 3
6719 Get/Set Channel 1 Custom Input
Points*
INT Number of Custom
Input Buffer Points
*(Only available when
Units is set to pH)
1 to 13 buffer points
7099 Channel 2
7479 Channel 3
6720 Get/Set Channel 1 Buffer A point
1*
FLOAT Custom Buffer A Point 1
*(Only available when
Units is set to pH)
0 to 14.00 pH
7100 Channel 2
7480 Channel 3
6722 Get/Set Channel 1 Buffer B point
1*
FLOAT Custom Buffer B Point 1
*(Only available when
Units is set to pH)
0 to 14.00 pH
7102 Channel 2
7482 Channel 3
6724 Get/Set Channel 1 Temperature
point 1*
FLOAT Custom Buffer Point 1
Temperature
*(Only available when
Units is set to pH)
-20.0°C to 150.0°C
7104 Channel 2 -4.0°F to 302.0°F
7484 Channel 3
6726 Get/Set Channel 1 Buffer A point
2*
FLOAT Custom Buffer A Point 2
*(Only available when
Units is set to pH)
0 to 14.00 pH
7106 Channel 2
7486 Channel 3
6728 Get/Set Channel 1 Buffer B point
2*
FLOAT Custom Buffer B Point 2
*(Only available when
Units is set to pH)
0 to 14.00 pH
7108 Channel 2
7488 Channel 3
6730 Get/Set Channel 1 Temperature
point 2*
FLOAT Custom Buffer Point 2
Temperature
*(Only available when
Units is set to pH)
-20.0°C to 150.0°C
7110 Channel 2 -4.0°F to 302.0°F
7490 Channel 3
6732 Get/Set Channel 1 Buffer A point
3*
FLOAT Custom Buffer A Point 3
*(Only available when
Units is set to pH)
0 to 14.00 pH
7112 Channel 2
7492 Channel 3
6734 Get/Set Channel 1 Buffer B point
3*
FLOAT Custom Buffer B Point 3
*(Only available when
Units is set to pH)
0 to 14.00 pH
7114 Channel 2
7494 Channel 3
6736 Get/Set Channel 1 Temperature
point 3*
FLOAT Custom Buffer Point 3
Temperature
*(Only available when
Units is set to pH)
-20.0°C to 150.0°C
7116 Channel 2 -4.0°F to 302.0°F
7496 Channel 3
6738 Get/Set Channel 1 Buffer A point
4*
FLOAT Custom Buffer A Point 4
*(Only available when
Units is set to pH)
0 to 14.00 pH
7118 Channel 2
7498 Channel 3
6740 Get/Set Channel 1 Buffer B point
4*
FLOAT Custom Buffer B Point 4
*(Only available when
Units is set to pH)
0 to 14.00 pH
7120 Channel 2
7500 Channel 3
6742 Get/Set Channel 1 Temperature
point 4*
FLOAT Custom Buffer Point 4
Temperature
*(Only available when
Units is set to pH)
-20.0°C to 150.0°C
7122 Channel 2 -4.0°F to 302.0°F
7502 Channel 3
To Next Page
Loading...
Need help?
General
