Network Video Recorder User Manual
19
dev.guardingvision.com.
1.5.3 Configure OTAP
OTAP (Open Thing Access Protocol) is an unified integrated standard and push-pull mode of
Default/LTS protocol in the public network and private network. After OTAP is enabled, other
applications may be able to remotely view videos through this protocol.
Before You Start
Ensure your device network is accessible through OTAP protocol.
Steps
1. Go to System → Network → Advanced → Platform Access.
2. Set Access Type as OTAP.
Figure 1-16 OTAP
3. Check Enable.
4. Set the parameters.
5. Click Apply.
To Next Page
Loading...
