Need help?Do you have a question about the LTS LTN8708-P8 and is the answer not in the manual?
General| Model | LTN8708-P8 |
|---|---|
| Category | Network Hardware |
| Incoming Bandwidth | 80 Mbps |
| Outgoing Bandwidth | 80 Mbps |
| HDMI Output Resolution | Up to 4K (3840 × 2160) |
| Audio Output | 1-ch, RCA (Linear, 1 KΩ) |
| SATA | 1 SATA interface |
| HDD Bays | 1 |
| USB Interface | 2 × USB 2.0 |
| USB Ports | 2 |
| Consumption (without HDD) | ≤ 10 W |
| Operating Humidity | 10% to 90% |
| Video Input | 8 Channel |
| IP Video Input | 8 channels |
| Video Output | 1 HDMI, 1 VGA |
| VGA Output Resolution | 1920 × 1080 |
| Decoding Format | H.265, H.264 |
| Recording Resolution | 8 MP |
| Synchronous Playback | 8-ch |
| Capability | 8-channel recording and playback |
| Capacity | Up to 10TB capacity for each disk |
| Max HDD Capacity | 10TB per HDD |
| Network Interface | 1 RJ45 10/100/1000 Mbps |
| PoE Interface | 8 independent PoE network interfaces |
| Supported Standard | IEEE 802.3 af/at |
| Power | 48 VDC |
| Power Supply | 48 VDC |
| Operating Temperature | -10 °C to 55 °C (14 °F to 131 °F) |
| Dimensions (W × D × H) | 315 × 240 × 48 mm |
| Dimensions | 315 × 240 × 48 mm (12.4 × 9.4 × 1.9 inch) |
Provides instructions for safely powering on, off, and rebooting the NVR.
Guides the user through setting the initial administrator password for device security.
Covers the steps for activating and adding IP cameras to the NVR.
Guides on setting up parameters for PTZ camera control.
Covers configuring presets, patrols, and patterns for PTZ camera movement.
Guides on setting encoding parameters for image quality and stream types.
Details how to set up recording schedules for cameras.
Explains how to configure motion detection and trigger recording.
Guides on setting up recording triggered by alarm inputs.
Describes how to configure recording for Video Content Analysis (VCA) events.
Explains how to set up redundant recording for data safety.
Covers methods for playing back recorded video files by channel.
Details how to play back recorded videos by selecting a specific date and time.
Explains how to search and play back videos based on event types like alarms.
Covers procedures for backing up recorded files to external devices.
Guides on configuring motion detection alarms and response actions.
Explains how to configure handling methods for external sensor alarms.
Details how to detect video loss and configure alarm response actions.
Guides on configuring video tampering detection and alarm responses.
Guides on configuring face detection rules and sensitivity.
Explains how to set up line crossing detection rules and directions.
Details how to configure intrusion detection rules for virtual regions.
Covers basic network configuration like IP address and working modes.
Details advanced network settings like PPPoE, DDNS, NTP, SNMP, and more.
Provides steps for initializing newly installed hard disk drives.
Covers adding and managing network HDDs like NAS or IP SAN.
Details how to manage HDDs by grouping them for recording.
Explains how to set HDD properties like Read-Only or Redundancy.
To Next Page
