Need help?Do you have a question about the LTS LTN8932-P16 and is the answer not in the manual?
General| Model | LTN8932-P16 |
|---|---|
| Video Output | 2 HDMI, 1 VGA |
| Type | NVR |
| Compression | H.265, H.264, MJPEG |
| USB Interface | 2 USB 2.0 |
| Alarm In/Out | 16/4 |
| Power Supply | 100 to 240 VAC, 50 to 60 Hz |
| Operating Temperature | -10 °C to 55 °C (14 °F to 131 °F) |
| Humidity | 10% to 90% |
| Audio Input | 1-ch, RCA (2.0 Vp-p, 1 KΩ) |
| Audio Output | 1 channel |
Provides instructions for properly powering on, shutting down, and rebooting the Network Video Recorder.
Guides the user through the initial device activation process, including setting an admin password.
Details how to use the setup wizard for essential NVR configuration steps like date, time, and network.
Covers the process of activating and adding network cameras to the NVR for surveillance.
Guides on customizing live view settings such as output interface, dwell time, and audio.
Explains how to set up parameters for controlling PTZ cameras before operation.
Covers customizing PTZ presets, patrols, and patterns for automated camera movements.
Details how to configure parameters affecting image quality, stream type, resolution, and encoding.
Explains how to set up schedules for automatic recording and capture of video feeds.
Guides on setting up motion detection parameters and scheduling recordings triggered by motion.
Covers configuring recording and capture actions triggered by alarm inputs.
Details setting up redundant recording and capture for enhanced data safety and reliability.
Covers locking recording files and setting HDD property to read-only to prevent overwrites.
Explains how to play back recorded files using instant playback and normal search methods.
Guides on configuring motion detection parameters and arming schedules for alarms.
Details configuring alarm responses like event hints, full-screen monitoring, and audible warnings.
Details general network settings like working mode, NIC type, IP address, and DNS server.
Provides steps for initializing a newly installed hard disk drive before use with the NVR.
Guides on setting HDD properties like read/write, read-only, or redundancy for data protection.
Describes how to check the status of installed HDDs for normal operation or potential failures.
Covers using S.M.A.R.T. and bad sector detection for HDD reliability monitoring.
Covers upgrading the NVR firmware via a local backup device or FTP server.
Details how to add, delete, and edit user accounts, including permission settings.
Provides detailed technical specifications for NVR models LTN8916/LTN8932 and P16 series.
Offers solutions for common problems like no image, audible warnings, and connectivity issues.
Lists compatible IP camera manufacturers, models, versions, and resolutions for integration.
To Next Page
