Need help?Do you have a question about the LTS LTN8716-P16 and is the answer not in the manual?
Capabilities for managing hard disk drives for storage.
Features for recording video and playing back recorded footage.
Handling of alarms and system exceptions.
Network capabilities and protocols supported by the NVR.
Procedures for properly powering on, shutting down, and rebooting the NVR.
Guide to setting an initial administrative password for device activation.
Steps to use the setup wizard for initial NVR configuration.
Steps to activate IP cameras before adding them to the NVR.
How to add IP cameras already detected on the network.
Modifying parameters of connected IP cameras and setting custom protocols.
Configuring cameras connected via Power over Ethernet interfaces.
Configuring cameras connected via built-in switch network interfaces.
Operations and functions available within the live view interface.
Customizing live view display options like output interface and dwell time.
Setting up parameters for Pan, Tilt, Zoom (PTZ) camera control.
Configuring PTZ camera presets, patrols, and patterns.
Setting video stream parameters like resolution and bitrate for recording.
Setting up a schedule for when the NVR should record video.
Setting up recording triggered by motion detection events.
Configuring recording to start when an alarm is triggered.
Setting up recording triggered by Video Content Analysis (VCA) events.
Manually starting and stopping video recording.
Setting up special recording schedules for holidays.
Setting up recording based on Point of Sale (POS) data integration.
Setting up redundant recording for data safety and reliability.
Organizing HDDs into groups for recording management.
Locking recorded files to prevent overwriting.
Methods for playing back recorded video files.
Playing back recorded video for a specific camera channel.
Searching and playing back recorded video based on specific date and time.
Searching and playing back recordings based on event types like alarms or motion.
Advanced search feature to locate motion events within specific areas.
Methods for backing up recorded video files.
Quickly exporting selected record files to a backup device.
Configuring motion detection sensitivity, area, and response actions.
Configuring handling methods for external sensor alarms.
Setting up alarms and responses for video signal loss.
Configuring alarms and responses for video tampering detection.
Configuring and setting up face detection capabilities.
Setting up virtual lines for detecting cross-line events.
Configuring virtual regions to detect intrusions.
Setting up basic network parameters like IP address and working mode.
Steps to initialize a newly installed hard disk drive.
General| Channels | 16 |
|---|---|
| Synchronous Playback | 16-ch |
| Video Input | 16-ch |
| Video Output | 1-ch HDMI, 1-ch VGA |
| HDMI Output Resolution | 4K (3840 × 2160) |
| VGA Output Resolution | 1920 × 1080, 1280 × 1024, 1280 × 720, 1024 × 768 |
| Decoding Format | H.265, H.264 |
| Recording Resolution | 8 MP/6 MP/5 MP/4 MP/3 MP/1080p/720p |
| Hard Disk | 2 SATA interfaces |
| Network Interface | 1 × RJ45 10M/100M/1000Mbps self-adaptive Ethernet |
| USB Interface | 1 × USB 2.0, 1 × USB 3.0 |
| Power Supply | 100-240V AC, 50/60Hz |
| Operating Temperature | -10 °C to 55 °C (14 °F to 131 °F) |
| Operating Humidity | 10% to 90% |
To Next Page
