Network Video Recorder User Manual
88
Step 6 Select the recording type to Motion.
Step 7 Drag the mouse on the time bar to set the motion detection recording schedule. Refer to Chapter
7.4 Configure Recording Schedule for details.
7.7 Configure Event Triggered Recording
You can configure the recording triggered by the motion detection, motion detection and alarm,
face detection, vehicle detection, line crossing detection, etc.
Step 1 Go to System > Event.
Step 2 Configure the event detection and select the channel (s) to trigger the recording when event
occurs. Refer to Chapter 11 Event and Alarm Settings and Chapter 12 VCA Event Alarm for details.
Step 3 Go to Camera > Encoding Parameters > Recording Parameters.
Step 4 Set the event main stream/sub-stream recording parameters for the camera.
Step 5 Go to Storage > Recording Schedule.
Step 6 Select the recording type to Event.
Step 7 Drag the mouse on the time bar to set the event detection recording schedule. Refer to Chapter
7.4 Configure Recording Schedule for details.
7.8 Configure Alarm Triggered Recording
You can configure the recording triggered by the motion detection, face detection, vehicle
detection, line crossing detection, etc.
Step 1 Go to System > Event > Normal Event > Alarm Input.
Step 2 Configure the alarm input and select the channel (s) to trigger the recording when alarm occurs.
Refer to Chapter 11 Event and Alarm Settings and Chapter 12 VCA Event Alarm for details for
details.
Step 3 Go to Camera > Encoding Parameters > Recording Parameters.
Step 4 Set the event main stream/sub-stream recording parameters for the camera.
Step 5 Go to Storage > Recording Schedule.
Step 6 Select the recording type to Alarm
Step 7 Drag the mouse on the time bar to set the alarm recording schedule. Refer to Chapter 7.4
Configure Recording Schedule for details.
To Next Page
Loading...
