5. Network Configuration
This chapter explains how to connect LT-4GPOEW1 to network via WAN connection or cellular.
5.1 Ethernet WAN Configuration
A. Go to “Network > Interface > Port” to change LAN1 to WAN port.
B. Go to “Network > Interface > WAN” to configure WAN parameters. Take static IP configuration as an
example. DHCP client and PPPoE type are optional according to your requirements.
Click “Save & Apply” button to make the changes take effect.
C. Connect WAN port to another router or modem.
D. Log in LT-4GPOEW1 web GUI via WAN port IP address and go to “Status > Network” to check if status
is “up”.
To Next Page
Loading...
