31
Stored Number/View
(continued)
5. To return to the Normal (display) Mode, press the Exit button or
begin again at Step 2 to see another stored number.
To view the feature stored on a call appearance/feature button OR the
last number you dialed OR a number stored on an AD button
1. Press the Menu button and then press the softkey below View
OR, if View is not available on your display, press the button.
2. Press the selected feature button.
Note: To view the last number you dialed, press , or to view
the number stored on an AD button, press the selected AD
button.
Feature assignment on the button or telephone number is shown.
3. To return to the Normal (call-handling) Mode display, press the Exit
button or repeat Step 2 to see another stored number.
Timer
The Timer (display) feature allows you to measure elapsed time. You can
use this feature in order to keep track of time spent on a call or task.
To see elapsed time (hours, minutes, seconds)
1. Press the Menu button and then press the softkey below
Timer (which exits you from softkey mode)
OR, if Timer is not available on your display, press the button
(if administered).
Elapsed time is shown.
2. To stop the timer and clear the display, press the Menu button and
then press the softkey below Timer again
OR, if Timer is not available on your display, press again.
Elapsed time is displayed for about three seconds and then
disappears.
View
Redial
Timer
Timer
To Next Page
Loading...
