Lucent Technologies PortMaster - Displaying User Information; Adding Users to the User Table

Configuring the User Table
7-2 PortMaster Configuration Guide
Displaying User Information
You can display the current users in the user table or the complete configuration
information for a specified user.
To display the current users in the user table, for example, enter the following
command:
Command> show table user
Name Type Address/Host Netmask/Service RIP
---------------------------------------------------------------------------
jozef Netuser negotiated 0000000000
adele Login User default Telnet
elena Netuser assigned 255.255.255.255 No
taffy Login User defaults PortMaster
john Netuser 192.168.7.8 0000000000 No
To display configuration information for a particular user, for example, use the following
command:
Command> show user elena
Username: elena Type: Dial-in Network User
Address: Assigned Netmask: 255.255.255.255
Protocol: PPP Options: Quiet, compressed
MTU: 1500 Async Map: 00000000
Adding Users to the User Table
You must add users to the user table before configuring any settings for them. The
username is a string of from 1 to 8 printable, nonspace ASCII characters. The optional
user password is a string of from 0 to 16 printable ASCII characters. You cannot add
users with blank usernames.
To add a login user to the user table, use the following command:
Command> add user Username [password Password]
To add a network user to the user table, use the following command:
Command> add netuser Username [password Password]