Using Internet Connections 16-9
Configuration Steps for an Internet Connection
4. If you notice a problem, do the following:
a. Reset the port.
b. Check your configuration.
c. Dial the ISP again.
d. Repeat this procedure until the connection is made correctly.
Contact your ISP if you are unable to connect as expected. The ISP might be able to
provide additional information.
5. When you have configured the PortMaster correctly, enter the following
commands to reset the port and save the configuration:
Command> reset s1
Command> save all
Testing the Network Hardwired Setup
To test a network hardwired connection, follow these steps:
1. Reset the newly configured serial port.
Command> reset s1
The network hardwired connection should be established within a few seconds.
2. Verify that the port status is ESTABLISHED by entering the following
command:
Command> show s1
3. If there is a problem, check your configuration.
Contact your ISP if you are unable to connect as expected.
4. When you have configured the PortMaster correctly, reset the port and
save the configuration.
Command> reset s1
Command> save all
To Next Page
Loading...