Lucent Technologies PortMaster - Associating a Modem with a Port

Using Automatic Modem Configuration
10-6 PortMaster Configuration Guide
Associating a Modem with a Port
To automatically configure a modem and associate it in the modem table with the port
it is attached to, use the following commands:
Command> set S0|all modem ModemName(short)
Command> reset S0|all
For example; to associate a U. S. Robotics V.34 modem with port S1 and configure the
modem, enter:
Command> set s1 modem usr-v34
Command> reset s1
usr-v32-p USR
Courier/Sportster
V.32bis PCMCIA
57600 AT&F1&W
usr-v34-p USR
Courier/Sportster
V.34 PCMCIA
11520
0
AT&F1S0=1&W
usr-v32 USR
Courier/Sportster
V. 3 2 b i s
57600 AT&F1S0=1&W
usr-v34 USR
Courier/Sportster
V. 3 4
11520
0
AT&F1S0=1&W
usr-spt-v32 USR Sportster
V. 3 2 b i s
57600 AT&F1S0=1S10=20S13.0=1&W0
usr-spt-336 USR Sportster 33.6 11520
0
AT&F1S0=1S10=20S13.0=1&W0
zyxel Zyxel U1496E 57600 AT&FM0&D2S0=1S2=1
Table 10-1
Factory Default Modem Table Entries
(Continued)
Modem Name
(Short)
Modem Name
(Long)
DTE
Rate Initialization String