Displaying Filters
9-8 PortMaster Configuration Guide
Creating SAP Filters
The Service Advertising Protocol (SAP) is an IPX protocol used over routers and servers
that informs network clients of available network services and resources. SAP packets
can be filtered only on output. You can filter SAP packets according to the following
information about the server that is advertising the service via SAP:
•Name
• IPX network number
• IPX node address
• IPX socket number
To create a SAP filter rule, use the following command—entered on one line:
Command> set sapfilter Filtername RuleNumber permit|deny
[server String][network Ipxnetwork] [host Ipxnode] [socket eg|gt|lt Ipxsock]
Displaying Filters
To display the filter table, use the following command:
Command> show table filter
To display a particular filter, use the following command:
Command> show filter Filtername
Deleting Filters
To delete a filter, use the following command:
Command> delete filter Filtername
To Next Page
Loading...