Configuration Steps for an Internet Connection
16-4 PortMaster Configuration Guide
c. Serial port settings (page 16-5 or page 16-6).
d. Dial-out location (page 16-7).
2. Test the configuration (page 16-8 or page 16-9).
3. Set network filtering (page 16-10).
Alternatively, you can configure a PortMaster with an ISDN port for an Internet
connection. See “Using ISDN for Internet Connections” on page 16-11.
Configuring Global Settings
Configure the global settings to the values shown in Table 16-1.
For more information about global settings, see Chapter 3, “Configuring Global
Settings.”
After configuring the global settings, enter the following command to save the
configuration:
Command> save all
Configuring Port Settings
You must configure settings for your Ethernet port and settings for either a dial-out or
hardwired connection on your asynchronous port.
Ethernet Interface Settings
Set the Ethernet parameters to the values shown in Table 16-2.
Table 16-1
Global Settings Values
Setting Command
Default IP gateway set gateway
192.168.5.6
To Next Page
Loading...