Lucent Technologies PortMaster - Page 257

Using Internet Connections 16-5
Configuration Steps for an Internet Connection
After configuring the Ethernet interface, enter the following commands to reset it and
save the configuration:
Command> reset ether0
Command> save all
For more information on Ethernet interface parameters, refer to Chapter 4,
“Configuring the Ethernet Interface.”
Serial Port Settings for Dial-Out
For continuous dial-out on a serial port, configure the port with the values shown in
Table 16-3.
Table 16-2
Ethernet Port Parameter Values
Setting Command
IP address set
ether0
address
192.168.200.1
Netmask set
ether0
netmask
255.255.255.0
Broadcast address set
ether0
broadcast high
Table 16-3
Serial Port Values for Continuous Dial-Out
Setting Command
Port type set
s1
network dialout
Protocol set
s1
protocol ppp
Speed 1 set
s1
speed
1 115200
Speed 2 set
s1
speed
2 115200
Speed 3 set
s1
speed
3 115200
Modem control set
s1
cd on
Hardware flow control set
s1
rts/cts on
Software flow control set
s1
xon/xoff off
Dial group set
s1
group
1