Configuration Steps for an Internet Connection
16-6 PortMaster Configuration Guide
Leave all other settings at their default values.
After configuring the serial port, enter the following commands to reset the port and
save the configuration:
Command> reset s1
Command> save all
For more information about asynchronous ports and configuring modems, refer to
Chapter 5, “Configuring an Asynchronous Port.”
Serial Port Settings for a Hardwired Connection
To establish a hardwired connection on a serial port, configure the port with the values
shown in Table 16-4.
Leave all other settings at their default values. After configuring the serial port, enter the
following commands to reset the port and save the configuration:
Command> reset s1
Command> save all
Table 16-4
Serial Port Values for a Hardwired Port
Setting Command
Port type set
s1
network hardwired
Protocol set
s1
protocol ppp
MTU set
s1
mtu
1500
Speed 1 set
s1
speed 1
115200
Modem control set
s1
cd on
Hardware flow control set
s1
rts/cts on
Software flow control set
s1
xon/xoff off
IP destination set
s1
destination
192.168.5.6
Netmask set
s1
netmask
255.255.255.0
RIP routing set
s1
rip off
Compression set
s1
compression on
To Next Page
Loading...