Using Synchronous V.25bis Connections 14-3
Configuration Steps for a Synchronous V.25bis Connection
Configuration Steps for a Synchronous V.25bis Connection
This example connects a PortMaster located in Boston with a PortMaster located in
Miami using a synchronous interface that is initiated on-demand by an ISDN or
switched 56Kbps connection.
To install your PortMaster, follow the instructions in your hardware installation guide. If
you need additional help, refer to the troubleshooting chapter of the installation guide.
The example in this chapter shows variables in
italics
. Change these values to reflect
your network.
Once you have assigned an IP address to the PortMaster, continue with the following
steps:
1. Configure the following settings for the PortMaster in Boston:
a. Global settings (page 14-4)
b. Ethernet interface settings (page 14-4)
c. Synchronous port settings (page 14-5)
d. Dial-in users (page 14-5)
e. Dial-out locations (page 14-6)
2. Configure the following settings for the PortMaster in Miami:
a. Global settings (page 14-8)
b. Ethernet interface settings (page 14-8)
c. Synchronous port settings (page 14-9)
d. Dial-in users (page 14-10)
e. Dial-out locations (page 14-11)
3. Test the configuration (page 14-12).
4. Troubleshoot the configuration (page 14-13).
Configuring the PortMaster in Boston
The PortMaster in Boston is being configured for a V.25bis dial-up synchronous
connection to the PortMaster in Miami.
To Next Page
Loading...