Safety Information
This guide contains instructions and
warnings that must be followed when
installing and using the Electric Vehicle
Supply Equipment (EVSE), and should
not be used for any other product.
Before installing or using the EVSE, read
this entire guide including the WARNING
and CAUTION markings.
The information in this guide does
not exempt the user from following all
applicable codes or safety standards.
Compliance for Class B Digital Device
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses, and can radiate
radio frequency energy and, if not
installed and used in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures:
- Reorient or relocate the receiving
antenna.
- Increase the separation between
the equipment and receiver.
- Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
- Consult the dealer or an
experienced radio/TV technician for
help.
Safety Information 6
To Next Page
Loading...