Need help?Do you have a question about the LUDLUM 26-1 and is the answer not in the manual?
General| Model | 26-1 |
|---|---|
| Category | Measuring Instruments |
| Display | LCD |
| Measurement Units | mR/hr |
| Power Supply | 9V battery |
| Operating Temperature | -10 to 50°C |
| Accuracy | ±15% |
Procedures for returning equipment to Ludlum Measurements for service.
Instructions for safely unpacking the instrument and verifying contents.
Details the required form for instrument repair or calibration shipments.
Step-by-step instructions for replacing the instrument's AA batteries.
Procedure to confirm the instrument's proper startup and functionality.
Guidance on using a check source for regular instrument calibration verification.
Explains how the instrument detects and indicates a malfunctioning radiation detector.
Describes the warning indicators for when the instrument measurement exceeds its range.
Overview of the instrument's buttons, modes, and basic operation.
Details on how to operate the instrument in RATE mode for current measurements.
Instructions for using MAX mode to capture and display the highest detected count rate.
Guide to using COUNT mode for performing counts over a predetermined time interval.
Details the measurement ranges for various units displayed on the instrument's LCD.
Explains the functions of the instrument's front-panel buttons and controls.
Provides general information about the instrument's setup and calibration process.
Lists the default configuration parameters and their corresponding factory values.
Step-by-step instructions for accessing the instrument's setup menu.
Details on how to adjust and save parameters within the setup mode.
Specifies the operating temperature, humidity, and environmental limitations.
Explains the meaning of warning symbols and cautions present on the instrument.
Outlines safe procedures for cleaning and performing basic maintenance on the unit.
Instructions for performing basic external cleaning and upkeep of the instrument.
Lists common spare parts for the Model 26-1 with their part numbers.
To Next Page
