Model 26-1 Frisker User’s Manual Section 5
Ludlum Measurements, Inc. Page 5-1 April 2017
Setup Mode
Warning!
Only advanced users or administrators should consider changing
any of the parameters in the following section. Incorrect settings
could jeopardize the safety of users depending on this instrument.
Setup Overview
Your instrument has been shipped from Ludlum Measurements only after
passing electronic checkout, a 30-hour burn-in process, and a careful calibration
process. Calibration papers are supplied with each instrument shipped from
Ludlum Measurements.
Recalibration should be accomplished after maintenance or adjustments have
been performed on the instrument. Recalibration is not normally required
following instrument cleaning or battery replacement. Recalibration does not
require any special tools or software to perform.
Ludlum Measurements offers a full-service repair and calibration department.
Not only do we repair and calibrate our own instruments, we also service most
other manufacturers’ instruments. Calibration procedures are available upon
request for customers who choose to calibrate their own instruments.
Note:
Ludlum Measurements, Inc. recommends recalibration at intervals
no greater than one year, assuming that regular operational checks
are performed. Check the appropriate local, state, and federal
regulations to determine required recalibration intervals.
Sectio
5
To Next Page
Loading...
Need help?
General
