EasyManua.ls Logo

Lufft SHM31 - Intended Use; Incorrect Use; Brand Names Used

Lufft SHM31
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Read before commissioning
6 Snow depth sensor SHM 31, V2.1
Maximum radiant output power
0.95 mW
Wavelength
635 nm
Pulse duration
> 400 ps
Pulse repetition rate
320 MHz
Beam divergence
0.16 mrad x 0.6 mrad
A
ttention
authorised, trained personnel should have access to the laser sensor.
1.
4 Intended use
The device must only be operated within the range of the specified technical data.
The device must only be used under the conditions and for the purposes it was designed
for.
The device must not be modified or converted; its operational safety and functionality
are then no longer guaranteed.
T
he following basic use is considered to be intended:
Measuring distances from fixed targets.
Measuring snow depth as a distance from the snow surface.
Assembling the sensor on a mast or mast bracket with the line of sight below a tilt angle
towards the ground, (also see the notes on laser safety).
Regular cleaning, checking measured results and maintenance.
1.5 Incorrect use
If the device is not assembled correctly:
It may not work, or may only work to a limited extent
It may be permanently damaged
It may fall down and hurt someone
If the device is not connected properly:
It may not work
It may be permanently damaged
It may cause an electric shock under certain circumstances
1.
6 Brand names used
A
ll brand names used in this manual are subject to the valid trademark rights and ownership rights of the
respective owner without restriction.

Table of Contents

Other manuals for Lufft SHM31

Related product manuals