GB Operating manual – multifunction measuring meter XA1000 / XP200 / XP400 • 08_2015 24
Settings 2/3:
97 Either specifies the period for automatic dimming of the colour
display or deactivates the function:
30 seconds, 1 minute, 5 minutes, off
98 Either specifies the period for automatic switch-off of the
colour display or deactivates the function:
10 minutes, 30 minutes, 1 hour, off
Note!
This function is deactivated during an automatic
measurement.
99 Switches signal tones/key tones on or off.
100 Sets the height above sea level (SL).
This value is i.a. required for the calculation of the relative air
pressure and other values.
This option can only be selected by using the cross control
below the colour display.
1. Press the "Down" key on the cross control until the
numerical value is selected.
2. Press the "OK" key on the cross control.
The first number is selected.
3. Press the "Left" or "Right" keys on the cross control to
select the number to be configured.
4. Press the "Up" or "Down" keys on the cross control to
increase or reduce the value to be configured.
5. Press the "OK" key on the cross control.
The single number is deselected.
101 Opens the next screen.
To Next Page
Loading...
Need help?
General
