Lukas S 700 E2 - 7. Dismantling the Equipment; Deactivation Following Operation; Closing Arms and Storing the Device

16
During cutting, the gap between the blade tips (in the transverse direction) must not be
exceeded,otherwisethebladeisindangerofbreaking:
ATTENTION!
Wherepossible,avoidcuttingthroughhigh-strengthpartsofthevehiclebody
(e.g. sideimpact protection).This mayresult in damageto the bladesor to
increasedwearandtear!
eDRAULICcuttingdevice max.gapatthebladetips
[mm] / [in.]
S 312 E2 3 / 0.12
S 377 E2 3 / 0.12
S 700 E2 3 / 0.12
S 788 E2
5/ 0.20
7. Dismantling the equipment / deactivation following operation
Onceworkhasbeencompleted,thedevicearmsshouldbecloseduntilthetipsareonlya
fewmillimetersapart.Thisrelievesthehydraulicandmechanicalstrainontheequipment.
Clean the rescue device after each operation and grease both the metallic and the
mechanicallymovableparts.
Greasingprovidesprotectionagainstexcessivewearandtearorcorrosion.
Avoidstoringtherescueequipmentinadampenvironment.
NOTE:
NeverstoretheeDRAULICdeviceswithfullyclosedarms!Byfullyclosingthe
armshydraulicandmechanicaltensionmaydevelopinthedevice.