LulzBot TAZ Quick Start Guide

Quick Start Guide
setting up your
TAZ 3D printer
1
Place the TAZ frame and Y axis assembly on a flat and
level surface. Remove four pieces of tape from the print
bed. Gently remove the tape from each end-stop
switch.
Download this document: www.LulzBot.com/StartHere
Remove Protective Pieces!
Locate and remove the gray foam block
used to hold the X axis carriage in place
during shipping.
Remove red protective packing clips
READ THE ENCLOSED USER MANUAL COMPLETELY
BEFORE POWERING UP YOUR TAZ 3D PRINTER
Mounting Printer Bed (Y Axis)
to Printer Frame
2
Locate the four Y axis bolts on the TAZ frame (see green
circles below). Turning counter clockwise, remove each
Y axis bolt and set aside.

LulzBot TAZ Specifications

General

Nozzle Diameter	0.5 mm (standard), interchangeable
Print Speed	Up to 200 mm/s
Max Hotend Temperature	300°C
Max Heated Bed Temperature	120°C
Connectivity	USB
Supported Materials	PLA, ABS, HIPS, PVA, PETG, Nylon, TPE, TPU, PC, wood-filled
Print Surface	PEI-coated borosilicate glass bed
Bed Leveling	Automatic
Operating System Compatibility	Windows, macOS, Linux
Power Requirements	100 - 240 VAC
Print Technology	Fused Deposition Fabrication (FDM)