Need help?Do you have a question about the LumaSense Impac IS 5 and is the answer not in the manual?
General| Protection Class | IP65 |
|---|---|
| Analog Output | 0/4 to 20 mA |
| Digital Interface | RS-232 |
| Power Supply | 24 V DC |
| Emissivity | 0.10 to 1.00 adjustable |
| Sighting | Laser aiming |
General safety advice for operating the pyrometer.
Safety precautions for the laser targeting light.
Safety regulations for electrical connections and potential hazards.
Detailed pinout for the pyrometer's connector.
Details on connecting the pyrometer to a PC via RS232 or RS485.
Operating and safety instructions for the laser targeting light.
Table showing spot sizes for different distances and optics.
Overview of the pyrometer's controls and DIP switches.
Setting the analog output signal (0-20 mA or 4-20 mA) via DIP switch.
Mapping of DIP switches to instrument settings like exposure time and output.
Configuring exposure time using DIP switches for measurement accuracy.
How to select between online and offline operating modes using DIP switch 4.
Adjusting emissivity for accurate temperature measurements.
Table of emissivity values for various common materials.
Details on setting basic parameters like range, material, and temperature units.
Configuration and operation of the integrated PID controller.
Using the self-tuning algorithm to optimize PID controller parameters.
Safety precautions to be observed during pyrometer servicing.
To Next Page
