Lumens LC200

35
*Note 1: Standby Mode: Applicable to firmware version 4.4.0.19 or later. Enable through the RS232/TCP
command.
9.
LC200 cannot find the
camera
1. Please link to the webpage of the camera to make sure that
[Setting] > [Video] > [Camera ID] / [Location] in the
webpage uses only English letters or numbers. LC200 cannot
find the machine if you use special characters and space.
2. When the LC200 is connected to a switch and the switch
IGMP function is on, it will not be able to search for cameras
in the local area network. Please disable the IGMP function
first and then search for cameras again.
10.
Maximum recording time
LC200 supports
The recording time LC200 supports is up to 12 hours.
24/7 recording is not supported