Lumex Splash User Manual

17
Symptom Possible Cause Solution Section
No lights appear
on hand control
when buttons are
pressed.
•Batteryisnot
connected correctly
to hand control.
•Insertbatterycorrectlyintobothtracks
on hand control and slide all the way to
theenduntilitclicks.
Section5
•Faultyelectronicsin
hand control.
•Contactsupplierorauthorizedservice/
repair center.
n/a
Suction feet will
not stick to the tub
surface.
•Frontsuctionfeet
are located over
rippled surfaces.
•Donotusebathlift. Section3
•Suctionfeetare
located on very
curved surfaces.
•Positionsuctionfeetonattersurface
of tub.
Section4
•Tubsurfaceisdirty/
dustyorenamelis
worn.
•Cleantubsurfaceandunderneath
suction feet before installing bath lift.
Section3
•Suctionfeetareold
ordamaged.
•Contactsupplierorauthorizedservice/
repaircenterforreplacements.
n/a
Bath lift tips
backwards in
highest position.
•Bathliftnotstored
properly after bath.
•Alwayslowerbathlifttobottomoftub
afteruse.(Checksuctionfeetsticktotub
beforeeachuse.)
Section7
•Frontsuctionfeet
are located over
rippled tub surface.
•DONOTUSEbathlift.Rippledsurfaces
prevent secure suction.
Section3
•Suctionfeetare
located on very
curved surfaces.
•Positionsuctionfeetonattersurfaceof
tub.DONOTUSEiffrontsuctionfeetdo
notsticktocontouredtubsurface.
Section4
•Suctionfeetnot
stickingtodirty/
dusty tub surface or
wornenamel.
•Cleantubsurfaceandunderneath
suction feet before pressing all 4 suction
feetrmlyontotub.
Section3
•Oldordamaged
suction feet will not
sticktotubsurface.
•Contactsupplierorauthorizedservice/
repaircenterforreplacements.
n/a

Lumex Splash Specifications

General

Brand	Lumex
Model	Splash
Category	Mobility Aid
Language	English