The global settings page is divided in ve sub menus:
CONTROL SOURCE
Here, you can set the type of protocol, the universe number, and the controller IP address for each control
source. If the IP address 0.0.0.0 is used all devices in the network generating the assigned control protocol
and universe can be the control source. The LumiNode will use an LTP merging policy between the rst
four sources that become available. When using sACN the priority is also important to consider.
Each control source can be a dierent protocol, universe, and controller IP.
Press Save to apply your settings.
DEVICE SETTINGS
In this menu, you can set:
Short name. Enter a name of maximum 17 characters to indicate the node on Art-Net. The following
characters cannot be used: ^[ -~]*$.
Long name. Enter a name of maximum 63 characters to indicate the node on Art-Net. The following
characters cannot be used: ^[ -~]*$.
ID number of the LumiNode. The ID number is used for indication only.
Press Save to apply your settings.
DEVICE INFO
The device info window shows the MAC address and serial number of your device.
MISCELLANEOUS
Web auth, for security reasons, a password can be enabled on the LumiNode’s web interface.
Click on the slider to enable web authentication, and type in your password.
Led slider allows you to change the brightness of the LEDs on the LumiNode.
Press Save to apply your settings.
15
To Next Page
Loading...
